All The Models Florida Series; All Models Paris Series - Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien

D28
drawing D29)
1. Remove the vermiculite baffle plate.
2. Remove the cast-iron back and side plates.
3. Remove the cast iron grate.
4. Remove the screws from the fan bracket, lift it from the left side and remove it. Be careful with the cables of the installation.
In the case of the corner and three-sided inserts of the Paris and
Versailles series, the steps would be as follows (see drawing
D30):
1. Remove the vermiculite side plates by pulling upwards
from the front.
2. Remove the baffle plate.
3. Remove the cast iron grate pulling it out from the sides.
4. Remove rear cast iron plates.
5. Remove the screws from the fan bracket, lift from the
left side and remove it. Be careful with the cables of the
installation.
PLACING / REPLACING THE STANDARD FRAME
All inserts in this series incorporate a standard frame. The standard frame is detachable for an easy installation.
To uninstall the standard frame, proceed as follows:
Front models (see drawing D31):
1. Remove the door, opening it and pulling it upwards.
2. Unscrew the frame screws, as indicated in the drawing.
3. Remove the frame and install the insert, fix it and reassemble the frame and the door.
Corner and three-sided models (see drawing D32):
1. Remove the rear screws from both the top and bottom frames and pull them out.
2. Remove the screws from the vertical frames and remove frames.
3. Install the insert, fix it and reassemble the frames.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
2.2.6

ALL THE MODELS FLORIDA SERIES

The standard frame included with the inserts is removable to make easier the installation and the repair /
replacement of the electrical components (fan, thermostat, etc.).
To remove the standard frame it is necessary unscrew the 4 screws of the frame (2 in each side) (see
drawing D28).
WARNING!! To be able to repair / replace the electrical components of the insert it is
essential to have a easy way to uninstall the frame.
2.2.7

ALL MODELS PARIS SERIES

TURBINE REPLACEMENT
In case of replacement of one of the electrical components, in
the models of the series Paris frontal, and models with lifting
door (Paris 70V-G and 90V-G), the operation of substitution can
be made without uninstalling the insert because they are placed
under the base. It is possible to access the components through
the combustion chamber by following the next steps. (see
33
D29
D30
D31
INSERTS