General Warnings; Important; General Description - Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien

1.

GENERAL WARNINGS

The installation of an insert must be done according to the local, national or European regulations.
Our liability is limited to the supply of the equipment. The installation must be done according to the procedures expected for this
kind of equipments, according to the indications included in this manual and the rules of the profession. The fitters must be qualified,
with official license and they will work for enterprises that accept responsibility of the installation.
Bronpi Calefacción, S.L. will not be responsible for the modifications made to the original product without the prior written permission as well
as for the use of non-genuine spare parts or pieces.
IMPORTANT!!!: this product includes a spray paint can inside the combustion chamber or oven (when applicable) which
must be removed before the ignition.
2.

GENERAL DESCRIPTION

The equipment that you have purchased contains the following pieces:
• Complete structure of the insert placed on the pallet.
• Inside the combustion chamber you can find: a box/bag with a thermal glove that allows us to handle the air controls, draft-diverter
valve, door, etc, in order to avoid burns. One electric blowtorch (batteries not included) except Florida Series, Rioja and Coliseo
models, in order to facilitate fire's ignition. One spray paint can to repair possible scratches. The Coliseo and Rioja models incorporate
inside the smoke outlet collar, which has to be placed by the installer. One small rake in order to poke the fire and move the embers
and a baffle plate (according to the model). The models Rioja and Coliseo lack of rake.
The equipment is made of several elements of steel sheets welded, with different thickness, and, depending on the model, pieces of cast iron
or vermiculite (refractory material that covers the walls). It also has a door with vitro ceramic glass (resistant up to 750ºC) and ceramic cord
for the air tightness of the combustion chamber.
Heating is produced by:
a. Convection: because the air passes through the body and sump, or the heating through the hood of the facing in which the insert is
put.
b. Forced convection (only insert with turbines): thanks to the turbines placed on the bottom of the insert, the air at room temperature is
aspired and it is returned to the room at a higher temperature.
c. Radiation: through the vitro ceramic glass and the body the heat is irradiated towards the environment.
The models have some settings for a perfect combustion control:
The primary air intake controls the air that passes through the ash pan and the grate towards the fuel. The primary air is necessary for the
combustion process.
The ash pan should be emptied frequently so that the ash does not block the primary air intake for the combustion. Also, the primary air
rekindles the fire.
• The models of the Kenia series have this air intake control hidden behind the lower cover and its movement is from the left to the right
(see drawing D2). The higher entry air is corresponded with the higher side of the triangle.
• In Panamá series models, this regulation is located under the door. It is the regulation located in the middle (see drawing D3). When
the regulation is completely extracted (outside) it means a greater air entry.
D1
• In models of the Florida series, Paris series, Londres, Madrid Visión and Canadá Visión this control is placed under the door. The
higher entry air is corresponded with the higher side of the triangle (see drawing D4).
• In model Canadá, Mérida, Mérida-P, Me Lugo, Rioja and Coliseo this control is placed on the bottom of the door (see drawing D5).
• In all the other models, the control is placed at the ash pan (see drawing D6).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D2
24
D3
INSERTS