Specifications According To The Model; Model Londres, Londres Vision, Londres-T And Londres-T Vision - Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien

The parameters are described in the following table
SECONDARY MENU PARAMETERS
Temperature Fan Activation
Temperature Fan Activation Hysteresis
ALARM Temperature Activation
SAFETY Temperature Activation
SAFETY FAN Temperature Activation
SAFETY Function Enable
SAFETY FAN Function Enable
STANDBY Function Enable
BUZZER Function Enable
Fan Speed P01
Fan Speed P09
Fan Speed P10
Temperature Range of Regulation for Proportional Modality
• P01 / P09 / P10 Speed REGULATION (parameters U01 / U09 / U10)
- Enter in SECONDARY Menu
- Select the parameter to verify/modify : the fan works automatically at the set speed
- Modify the value until the desired value : in this way it is possible to control the speed directly.
- Memorize by pushing button P4
- Eventually repeat the operation for the other speeds/parameters
- To exit, wait about 10 seconds.
Supply:
Protection:
Temperature Probe:
Output:
Dimensions:
Applied Rules:
2.2

SPECIFICATIONS ACCORDING TO THE MODEL

2.2.1

MODEL LONDRES, LONDRES VISION, LONDRES-T AND LONDRES-T VISION

Admission of fresh air
Due to the high power of this models of inserts it is advisable to foresee an air intake coming from outside the room to avoid the overheating
of the equipment.
Isolation of the insert: advantages and drawbacks
Some thermal insulator can be placed between the facing and the insert.
Every way, all cautions must be taken to avoid an overheating of the walls and every constructional elements nearby the equipment (for
instance, wooden beam), and at the moment of the placement these materials will be insulated according to the rules.
Advantages:
- A lower loss of heat. This is only valid in case of the insert is beside an outer wall. Unless the case the heat will not be lost, it will be
dissipated in the first step by the facing and the to the adjacent rooms.
- Reduction of temperature in case of flammable elements near the insert.You should always watch the air intakes for the convection
(on the bottom, laterals and rear of the insert) are not obstructed. Ideally, ceramic fibre or Rockwool rigid panels, whose fibres are
agglomerated by some bonding agent, shall be used.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
CODE MIN
SET 30º
iSt 1º
TAL 100º
TSI 80º
TSA 100º
SIC 0 [off]
SAF 0 [off]
Stb 0 [off]
Enb 0 [off]
U01 00
U09 00
U10 00
DEL 20º
230 Vac ±10%~ 50HZ: EMI filter on side
Internal Fuse
Working Temperature: -50°C / 250 °C
Range of Measure: 0 – 180 °C: ± 1°C
FAN: 230 Vac Imax: 0,8A/1,5A high power version
Inbox Controller 120 x 80 x 50 [mm]
EN 60730-1 50081-1 EN 60730-1 A1 50081-2
29
DEFAULT MAX
45º 99º
2º 35º
120º 180º
100º 140º
135º 180º
1 [on] 1 [on]
1 [on] 1 [on]
1 [on] 1 [on]
1 [on] 1 [on]
16 100%
70 100%
100 100%
20º 100º
INSERTS