Model Kenia-110, Kenia-110 Visión, Kenia-100D And Kenia-110 Dvisión; 2.2.5 All The Models Kenia Series - Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien

WARNING!! The thermometer shows the cooking temperature of the oven, it never shows the combustion chamber
temperature.
The maximum cooking temperature for the oven is 200-230ºC. If the thermometer shows that the oven reaches a higher
temperature, this means that the equipment has been overloaded and this will invalidate the warranty.
- Tray. It is made of stainless steel. In order to avoid the damage of the tray, it is recommended to extract it outside the oven when it is
not being used.
- Roasting grille If you prefer, instead of the tray you can use a roasting grille of 38x47cm. In order to avoid the damage of the tray, it is
recommended to extract it outside the oven when it is not being used.
- Ceramic pieces They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
The inside of the oven of this model is composed for 4 pieces (2 guides, ceiling and rear) made in stainless steel removable to extract them
and make easier the cleaning.
To remove the pieces we will follow the next steps (see drawing D25).
1. Remove the ceiling, slipping it out.
2. Remove the laterals guides hanging in 4 supports. To remove it you have to raise the guide and then pull it off.
3. Remove the rear hanging in two supports.
2.2.4 MODEL KENIA-110, KENIA-110 VISIÓN, KENIA-100D AND KENIA-110 D
VISIÓN
These inserts have a switch with only 2 positions: 0 and 1 but it is provided with a
potentiometer which we can adjust the revolutions of the 4 fans (see drawing D26).
D27
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS

2.2.5 ALL THE MODELS KENIA SERIES

The standard frame included with models Kenia is
removable. To place an optional frame (M-20, M-21, etc.)
it is necessary to remove the standard frame and then replace the optional one with the same drills. To
remove the standard frame it is necessary unscrew the 4 screws of the frame (2 in each side). Then, place
and screw again the new frame (see drawing D27).
WARNING!! If the insert is installed and covered and you want to buy another new one
optional frame it is important to advice of this to your distributor when you are going to
ask for it.
32
D24
D25
D26
INSERTS