Model Everest; Model Everest Visión - Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien

Heat exchanger (only model Londres-V)
The heat exchanger that cross the hood of the insert must not be blocked, it is necessary
to leave the holes open in order to achieve a better ventilation of the insert, increasing its
performance. (see drawing D21).
Replacement of the electrical components (only models Londres-T and Londres-T Visión)
It is compulsory to leave an access in the central low part of the masonry or facing to the repair
/ replacement of the turbine in case of breakdown. This register may be a grille with minimal
measures 400x200mm (wide x high).
Placement of optional frames
The standard frame included with models Londres, Londres-V, Londres-T and Londres-T Visión are removable. To place
an optional frame (M-8, M-9, etc.) it is necessary to remove the standard frame and then replace the optional one with the
same grills. To remove the standard frame it is necessary unscrew the 4 screws of the frame (2 in each side). Then, place
and screw again the new frame (see drawing D22).
WARNING!! If the insert is installed and covered and you want to buy another new one optional frame it
is important to advice of this to your distributor when you are going to ask for it.
2.2.2

MODEL EVEREST

Some models include on the top an oven with an hermetic oven chamber. The base of the oven is made of refractory brick (it absorbs
heat and irradiates it). Heating is produced when the smoke passes through the sides and the upper part of the oven. On the roof of
the oven there is one pipe that connects the cooking chamber with the smoke outlet in order to remove the gas generated in the oven.
The oven has the following components:
- Thermometer It is disassembled and you can find it in the baking
tray. It shows the cooking temperature of the oven. To install it, it is
necessary to introduce the sheath through the hole of the door and,
then, put the nut (see drawing D23).
WARNING!! The thermometer shows the cooking temperature
of the oven, it never shows the combustion chamber
temperature.
The maximum cooking temperature for the oven is 200-230ºC.
If the thermometer shows that the oven reaches a higher temperature, this
means that the equipment has been overloaded and this will invalidate the
warranty.
- Tray. It can be adjustable in two different levels according to the slot that we use. In order to avoid the damage of the tray, it is
recommended to extract it outside the oven when it is not being used.
- Refractory bricks. They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
2.2.3 MODEL EVEREST VISIÓN
This model include on the top an oven with an hermetic oven chamber. The base of the oven is made of ceramic material (it absorbs heat and
irradiates it). Heating is produced when the smoke passes through the sides and the upper part of the oven. On the roof of the oven there is
one pipe that connects the cooking chamber with the smoke outlet in order to remove the gas generated in the oven.
The oven has the following components:
- Bimetallic thermometer It is disassembled and it place is the glass of the oven.. To install it, it is necessary to introduce the
thermometer through the hole of the door and, then, put the rubber and the nut on the backside (see drawing D24).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 31
D21
D22
D23
INSERTS