Bronpi KENIA Série Instructions D'installation, D'utilisation Et D'entretien page 27

Triple combustion
In Panamá series models, the regulation located under the door to the right of the ash pan, regulates both
the double and triple combustion. With this regulation open (regulation completely extracted, outside), it is
possible to introduce hot oxygen twice into the combustion chamber, thanks to itineraries designed by Bronpi.
This combustion process makes the most of the calorific power of the wood, while reduces the most harmful
emissions as well as the consumption of wood.
Draft-diverter valve
The inserts of the Kenia, Madrid, Canadá and Panamá series are provided with an adjustable draft-diverter
valve, with automatic opening that allows the control of the draw.
It is possible to place properly the draft-diverter valve when we open the door thanks to the screw on the
central higher of the frontal zone (turn right = open valve / turn left =close valve). The draft-diverter valve will be
opened automatically at the open of the door regardless of its position in order to avoid the exit of smoke to the room (see drawing D13).
Smoke outlet collar
In the Coliseo and Rioja models, the installer must set the
smoke outlet collar. This allows the installer to get an easier
installation, specially when the appliance is going to be
inserted in a preexisting fireplace whose height is similar to the
height of the appliance (see drawing D14).
In order to install it, it is necessary to access from the inside of
the combustion chamber and proceed as follows:
1. Remove the baffle plate.
2. Place the ceramic glue that is supplied on the smoke
outlet collar, to ensure its tightness with the appliance.
3. Screw the ring to the ceiling of the insert itself with the
three screws supplied.
4. Do not forget to install the baffle plate again before using the insert.
Baffle plate
The baffle plate is a fundamental part for the proper operation of the insert. It must be placed in the right position and the insert must not
be used without the baffle plate. This would invalidate the warranty.
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a fast combustion, excessive wood consumption and
the overheating of the equipment.
Due to safety reasons during the transport, in some models, the baffle plate is not assembled. You will find it inside the combustion chamber.
The correct position should be the following one (see drawing D15).
Some models such as Londres and Londres-T have a double baffle-plate which the same function (see drawing D16).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
1
D16
26
D14
D15
2
D13
INSERTS