Adjusting The Brightness - Comeg DUO Full HD Manuel D'utilisation

5
Use of the device
5.2.4 Mode selection: rigid or fl exible
• The camera is in rigid mode by default. This mode must be used if you are using an
endoscope equipped with lenses.
• If you are using a fl exible endoscope equipped with optical fi bre, change over to fl exible
mode:
. Via the interface: press the
. Via the camera head: perform a long press on the right button [S4]
An OSD message, represented by "F", appears on the screen whenever this mode is active. An OSD message, represented by "F", appears on the screen whenever this mode is active.
• To deactivate the mode, press the
on the camera head button.

5.2.5 Adjusting the brightness

• To adjust the brightness of the light source, you can:
. Press the + or - buttons on each side of the slider
. Or drag the slider itself to the left or the right.
. If the buttons are set to control the light (see 5.4.2 Settings), you can perform a short
press on the left button [S3] of the camera head to reduce the light intensity and perform a
short press on the right button [S4] of the camera head to increase it.
64
button
button again on the interface, or long press again
Function deactivated
Function activated