Device Installation - Comeg DUO Full HD Manuel D'utilisation

4

Device installation

No special training is required to install the device.
4.1 Connection
• Connect the power cord to the cable connector at the rear of the device [C7] .
• Connect a video lead to one of the following video outputs: HDMI [C4] or SDI [C6].
• Connect the other end of the video lead to the monitor video input.
HDMI SDI
PO WER
4.2 Switching On
• The device is fi tted with a switch [S1] located on the rear of the device. The device is
switched on by setting this switch to the I position.
• The screen on the device [L1] will then come on in standby mode; touch the screen to exit
standby.
60