Güde GMD 400 Traduction Du Mode D'emploi D'origine page 18

GB
Thank you for buying the mini lathe Güde GMD 400 and for your trust in our products.
!!! Please read the operating manual carefully before starting the machine
Any technical questions? Complaints? In need of spare parts or operating manual?
On our web pages www.guede.com
your machine in case of any claim, we need to know serial number, product number and year of production. You can find all these data on the
GB
type label. To have them handy please write them down in here:
Serial number:
Tel.: +49 (0) 79 04 / 700-360
For reprints, even partial, permission required. Technical changes reserved
A.V. 2
Labeling:
Product safety:
Product complies with EU
standards
Restrictions:
General prohibition (in connection
with other icons)
Wearing jewels prohibited
Machine not to be used in wet
conditions
Warnings:
Warning/Caution
Warning against dangerous
voltage
Protective equipment to be closed
before putting the machine into
operation
Commands:
Please read the Operating
Instructions before using the
machine
Protective gloves to be worn!
we will help you fast and without needless bureaucracy. Please help us so we can help you. To identify
Product number:
Tel.:
Wearing loose clothing
prohibited!
No long hair
Pulling the cable prohibited
Warning against thrown-off
items!
Engine to be switched off and
system plug to be disconnected
before any repair, servicing or
cleaning
Protective equipment not to be
opened or removed when the
engine is running
Eye and ear protection to be
used!
Protective mask against dust to
be worn!
+49 (0) 79 04 / 700-360
Environmental protection:
Dispose the waste professionally.
.
Do not litter
Malfunctioning and/or disposed
electric or electronic devices must
be disposed to authorized scrap-
.
yards
Package:
This side up
Technical specifications:
Connection
Vario gearbox
Max. workpiece height
Machine description (pic. 1+2)
1. Gearbox with sprocket wheels
2. Three-jaw chuck fastening screw
3. Three-jaw chuck
4. Chuck jaw
5. Catches for lathe tool
6. Chucking lever for tool holder
7. Tool holder
8. Protective cover
9. Centring point
10. Sleeve with scale
11. Chucking level for quill
12. Tailstock
13. Hand lever for sleeve
14. Lathe bed
15. Machine bath
16. Guide screw
17. Crank with scale for manual feed (knife slide)
18. Toothing for feed
19. Feed blocking lever
20. Scale for angular turning
18
!!!
Year of production:
Tel.: +49 (0) 79 04 / 700-360
Similar pictures
.
Packing material made of
cardboard can be disposed in
.
scrap-yards
Engine power
Max. workpiece length
Weight
!!