Pre-Use Checks; During Use - Mondolfo Ferro AS 914 TI Manuel D'utilisation

• The employer shall insure that no employee services any rim wheel unless the employee
has been trained and instructed in correct procedures of servicing the type of wheel being
serviced, and in safe operating procedures.
• Information to be used in the training programme shall include, at a minimum, the ap-
plicable information contained in this manual.
2. The employer shall ensure that each employee demonstrates and maintains the ability
to service rim wheels safely, including performance of the following tasks:
• Demounting tyres (including deflation).
• Inspecting and identifying rim wheel components.
• Mounting tyres.
• Using any restraining device, cage, barrier, or other installation.
• Handling rim wheels.
• Inflating the tyre.
• Understanding the necessity to stand back from the tyre changer during tyre inflation
and during inspection of the rim wheel following inflation, never leaning over.
• Installing and removing rim wheels.
3. The employer shall evaluate each employee's ability to perform these tasks and to
service rim wheels safely, and shall provide additional training as necessary to assure
that each employee maintains his or her proficiency.

1.6. PRE-UsE ChECks

Before beginning work, carefully check that all components of the machine, especially rub-
ber or plastic parts, are in place, in good condition and working properly. If the inspection
reveals any damage or excessive wear, no matter how slight, immediately replace or repair
the component.

1.7. DURINg UsE

In the event you hear any strange noise or feel unusual vibration, if a component or system is not
operating properly, or if there is anything unusual at all, stop using the machine immediately.
• Identify the cause and take any necessary remedial action.
• Contact your supervisor if necessary.
Never allow any bystander to be within 20 feet of the machine during operation.
To stop the machine in an emergency:
• disconnect the power supply plug;
• cut off the compressed air supply network by disconnecting the shut-off valve (snap coupling).
AS 914 TI User Manual
18