- Remove the plug and screw in the valve + pressure gauge unit "I" (Fig.3).
- Screw down the adjustment knob "L" (Fig.3).
- Remove the plug and fi t the rubber hose "M" on connection "O" and tighten the hose
clip "N" (Fig.4).
- Open the bead-breaker arm "q" (Fig.5).
- Fit the distance bush "P" over the bead breaker cylinder rod and close the beadbreaker
arm inserting the cylinder rod through the swiveling block.
- Hoist the machine off the pallet and proceed with installation.
AS 914 TI User Manual
F
21