It may be necessary to break the bead at several points to free it completely
9.4. CLAMPINg ThE WhEEL
- Move manually the mounting head arm at
side, in not-working position (Fig. 17).
- Place the wheel on the sliding clamp table
with the narrow side of the wheel's drop
centre facing upward (tires must be removed
and re-fitted only from the narrow side).
- Press pedal
clamps to the outside of the table (Fig.18) if
you wish to clamp the rim on the outside as
shown in Figure 18 (recommended for alloy
rims).
- alternatively, keep pedal
table (Fig.19) if you wish to clamp the rim on the inside (Fig.19).
30
NOTICE
to bring the sliding
pressed to bring the sliding clamps to the centre of the
18
17
19
AS 914 TI User Manual