Mondolfo Ferro AS 914 TI Manuel D'utilisation page 42

PROBLEM
Table top will not turn in
one direction.
Table top will not turn in
either direction.
Table top makes a third of
a turn and then stops.
Table top does not clamp
rim.
Table top demounts or
mounts tires with difficulty.
Vertical slide lifts off too
much or too little from
the rim.
Rim rest is blocked all the
way out or all the way in.
Inflation gauge needle
does not go back to "0".
Avoid personal injery or death.
The "spare parts" handbook does not authorise the user to carry out any work on
the machine other than the operations specifically described in the User Manual,
and is only intended to enable the user to provide the technical assistance service
with precise information in order to minimise response times.
42
LIkELY CAUsEs
❏ Reverser switch broken
❏ Reverser switch broken.
❏ Belt broken.
❏ Gear motor jammed.
❏ Fuse blown.
❏ Gear motor seizing.
❏ Table top cylinder de-
fective.
❏ Clamping slide grippers
worn.
❏ Insufficient belt tension. ❏ Adjust belt tension or
❏ Clamping plate not ad-
justed.
❏ Foreign body jamming
mechanism.
❏ Defective gauge.
❏ Gauge damaged by
impacts
WARNING
REMEDIEs
❏ Change reverser switch.
❏ Change reverser switch.
❏ Change belt.
❏ Change gear motor.
❏ Change fuse.
❏ Change gear motor.
❏ Change table top cylinder.
❏ Change sliding clamp.
change it.
❏ Adjust plate.
❏ Remove foreign bodies.
❏ Change gauge.
AS 914 TI User Manual