Electrical And Pneumatic Connections - Mondolfo Ferro AS 914 TI Manuel D'utilisation

1.2.c. ELECTRICAL AND PNEUMATIC CONNECTIONs
The dimensions of the electric hook-up
used must be suitably sized in relation to:
• the electric power absorbed by the ma-
chine, indicated on its data plate (Fig. 1);
• the distance between the machine and
the power supply hook-up point, so that
An effective grounding connection is essential for correct operation of the machine.
Make sure the available pressure and the rendered capacity of the compressed air system
are compatible with those required for correct machine operation - see the "Technical Data"
section. For correct machine operation, the compressed air supply line must provide a
pressure range from no less than 8.5 bar to no more than 16 bar and guarantee an air flow
rate greater than the average consumption of the machine, which is equal to 187 Nl/min.
For correct equipment operation, the air produced must be suitably treated (not
above 5/4/4 according to IsO 8573-1)
AS 914 TI User Manual
Mod.
V
A
kW
Hz
Ph
bar7psi
Port.max
voltage drops under full load do not exceed 4%
(10% during start-up) compared with the rated
voltage specified on the data plate.
- The operator must:
• fit a power plug on the power supply lead in
compliance with the relevant safety standards;
A
• connect the machine to its own electrical con-
nection - A, Fig. 1a - and fit a differential safety
circuit-breaker with 30 mA residual current;
• fit fuses to protect the power supply line, rated
as indicated on the general wiring diagram in
this manual;
• connect the machine to an industrial socket;
the machine must not be connected to domestic
1a
sockets.
NOTICE
NOTICE
ISO9001
QUAL. SYS. CERTIFIED
ANNO DI COSTRUZIONE /
Code
MANUFACTURED
X-XXXXXXXX/XX - XX
Serial N.
XXXXXXXXX
1
15