Mondolfo Ferro AS 914 TI Manuel D'utilisation page 39

Verify that both upper and lower tyre beads and
rim bead seat have been properly lubricated with
an approved mounting paste.
- Make sure that the wheel is secured to the table
top with inside clamping (Fig. 32a).
- Bring the horizontal arm in its work position (Fig.
32b).
- Lower the vertical rod until it touches the rim
(Fig. 32c).
- Lock the vertical rod in this position.
- Remove valve core and connect the Doyfe con-
nector on the air hose to the valve stem (Fig. 32d).
- Hold the tyre with your hands and lift
it until there is a slight gap between
the lower bead and bottom edge of
the rim in order to close the upper
bead and the top of the rim (fig. 32d).
- Fully press the inflation pedal down
for a short period to the bead seating
position (fig. 32f). The tyre will expand
and the beads will seat.
- Release the wheel from the sliding clamps on the
table top (Fig. 32e).
- Inflate the tyre by operating the proper pedal (Fig.
32d) in inflation position (average) (Fig. 32g) at short
intervals; check the pressure gauge frequently to make
sure that the pressure NEVER exceeds the maximum
pressure specified by the tyre manufacturer.
AS 914 TI User Manual
32a
32b
YES
32c
32d
NO
32e
32f
32g
39