Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.3. BEAD BREAkINg

- Fully deflate the tyre, removing the valve (Fig. 14).
- Set the stroke end of the breaker arm (see Figure 15) to the
width of the rim. This will avoid (especially if you operate
on low profile tires and with the particularly cold side),
excessive stress, which can damage the tire.
- Position the wheel as shown in fig.15a and move the bead
breaking shoe near the rim edge.
During the bead breaking operation, you are advised to keep the turntable closed
(clamp gripper towards the centre).
- Press the pedal
- Repeat this operation on the other side of
the wheel.
- After detaching the beads, remove the old
balancing weights.
- Thoroughly lubricate the sides of the tyre
around the entire circumference of the lower
and upper bead to facilitate the demounting
and avoid damaging the beads (fig.16).
AS 914 TI User Manual
15
NOTICE
(fig.15a) to operate the bead breaker and detach the bead.
14
15a
16
29

Publicité

Chapitres

Table des Matières
loading

Table des Matières