Transport And Installation - Abicor Binzel AutoGuide Plus Instructions D'assemblage

AutoGuide Plus
6 Commissioning
DANGER
Risk of injury due to unexpected start
The following instructions must be followed during all maintenance, servicing, disassembly and repair work:
• The AutoGuide Plus system must be switched off when the safety circuit of the entire system is interrupted
(e.g., the cell door is opened) or when a higher-level emergency off button is pressed.

6.1 Transport and installation

CAUTION
Risk of injury
Physical injury due to falling devices and add-on components.
• Use an appropriate lifting tool with load handling attachment for transporting and installing the AutoGuide Plus.
• Avoid abrupt lifting and setting down.
• Do not lift the components over persons or other devices.
• Transport the components in an upright position.
• Wear your personal protective equipment: safety shoes with steel toe caps, protective gloves, safety helmet,
ear protectors.
• Send bystanders out of the danger zone.
• Note the weight of the individual components.
 3.1 Technical data on page EN-5
CAUTION
Risk of toppling
Physical injury or damage to components due to improper assembly.
• Disconnect the supply lines.
• Place the components on a suitable base (flat, solid, dry) on which they will not topple over.
NOTICE
• Ensure clear access to the control elements and connections.
• Protect the components against rain and direct sunlight.
• Use the device only in dry, clean and well-ventilated rooms.
MON.0016.0 • 2021-02-05
6 Commissioning
EN - 11