Abicor Binzel AutoGuide Plus Instructions D'assemblage page 45

AutoGuide Plus
6.1.2 Mounting on the welding system
1
2
3
4
1 Mounting plate
2 Terminal strips (4 pieces)
Fig. 9 Mounting on the welding system
1 Fix the mounting plate (1) to the welding system.
2 Mount the cross slide (4) to the mounting plate (1) using cylinder head screws (3) and terminal strips (2).
Tightening torque 6 ± 0.5 Nm.
6.1.3 Assembly of MIG/MAG welding torch
7
6
5
4
1 Hose guides
2 Cylinder head screws M6 × 14 (4 pieces)
3 Protection plate
4 Adapter plate
Fig. 10 Assembly of MIG/MAG versions
1 Mount the adapter plate (4) on the grooved plate (5) of the front traverse carriage (7) so it is centered using the provided
sliding blocks (6) and the cylinder head screws (2). Tightening torque 7 ± 0.5 Nm.
2 Tighten the protection plate (3) using sliding blocks (6) and cylinder head screws (2) to the traverse carriage's grooved
plate (7). Tightening torque 7 ± 0.5 Nm.
3 Manually tighten the provided hose guides (1) as needed in the upper holes of the protection plate (3).
MON.0016.0 • 2021-02-05
Borehole diagram for the mounting plate (1)
3 Cylinder head screw M6 × 16 (8 pieces)
4 Cross slide
5 Grooved plate
6 Sliding blocks (4 pieces)
7 Front traverse carriage
6 Commissioning
1
2
3
EN - 13