Camera Settings - Abicor Binzel AutoGuide Plus Instructions D'assemblage

7 Operation

7.3.4 Camera settings

Fig. 18 Camera settings
"Laser ON" appears in the display once the control is connected to the laser's sensor head. The sensor head can be
controlled from here.
Laser ON/OFF
Job no.
Angle of the camera
Tab. 11 Parameters to be set
Workpiece
Fig. 19 Angle of the camera
Look ahead compensation
Maximum time for invalid data
Home position
TeachIN
First position of correction
Camera offsets
Tab. 12 Parameters to be set
EN - 18
Switch the laser at the sensor head on and off
Program for camera sensor
 Operating instructions for sensor
Horizontal angle of camera
 Fig. 19 Angle of the camera on page EN-18
Reference
0 mm
Time delay.
This results from the delay path of the sensor (TCP) and the welding speed.
The system switches off after a certain amount of time if the sensor does not
recognize a joint.
Resting position of the cross slide Customized setting is possible.
Adopt the current axis position values.
Position from which the system starts the tracking.
Programmable start point (working position).
The system switches the signal in position (Ready to weld) once the start point
is reached.
AutoGuide Plus
0 mm
Reference
Workpiece
MON.0016.0 • 2021-02-05