Abicor Binzel AutoGuide Plus Instructions D'assemblage page 51

AutoGuide Plus
Data
No recognition
Test search
Confirm error
Ready to weld
Tab. 12 Parameters to be set
7.3.5 Counters
Fig. 20 Counters
Absolute counters
Absolute time
Time of cycle
Reset counters
Absolute time
Time of cycle
Time of last reset
Password
Tab. 13 Time counter
All counters can be reset by entering both passwords (1982) and pressing the "Reset" button.
MON.0016.0 • 2021-02-05
"Check detection" button: Call up the position parameters of the camera and
check the camera image.
"Start tracking" button (start tracking and when seam is recognized: drive to
work point): press the button to start the tracking cycle without an external
start signal.
Message is displayed if no valid data or camera image exists.
"Test searching" button: press this button to activate automatic approach
(tracking).
Press again to interrupt tracking.
Confirm the error messages.
Is shown after the set working position is set and the signal for the external
welding system is activated.
Shows the total running time of the system.
The counter is reset only after a "cold start".
Shows the total running time in automatic mode.
The counter is reset only after a "cold start".
Shows the current runtime of the system.
Shows the current runtime in automatic mode.
Shows the time since the last reset.
Universal password
7 Operation
EN - 19