Introduction - Mondolfo Ferro TBE155 Manuel D'utilisation

INTRODUCTION

The purpose of this manual is to provide the
owner and operator of this machine with a set
of practical and safe instructions for the use
and maintenance of the wheel aligner.
If these instructions are carefully followed,
the machine will give you the efficient and
long-lasting service that has always charac-
terised our products, thus making your work
considerably easier.
The following paragraphs define the levels of
danger regarding the machine, associated with
the warning captions found in this manual:
DANGER
Immediate hazards that could cause serious
injury or death.
WARNING
Hazards or unsafe procedures that could
cause serious injury or death.
CAUTION
Hazards or unsafe procedures that could
cause minor injury or material damage.
Read these instructions carefully before start-
ing the equipment. Keep this manual and all
illustrative material supplied with the machine
in a folder near the tyre changer, where it is
readily accessible for consultation by the ma-
chine operator.
The technical documentation supplied is consid-
ered an integral part of the machine, and must
always accompany the equipment if it is sold or
transferred to a new owner.
The manual is only to be considered valid for
the machine of the model and serial number
indicated on the data plate applied to it.
WARNING
Comply with the contents of this manual:
The producer declines all liability in the
case of actions not specifically described and
authorised in this manual.
38
Note
Some of the illustrations in this manual have
been taken from photographs of prototypes; the
standard production model may differ slightly
in certain respects.
These instructions are for the attention of
persons with basic mechanical skills. We have
therefore condensed the descriptions of each
operation by omitting detailed instructions re-
garding, for example, how to loosen or tighten
the fixing devices on the machine, etc.
Do not attempt to carry out procedures which
exceed your level of proficiency, or which you
do not have experience with.
If assistance is required, contact an authorised
service centre.
- Operator's manual TBE 155
- E
nglIsh