Mondolfo Ferro TBE155 Manuel D'utilisation page 59

26) Turn the turntable clockwise until the gripper
is in the 9 o'clock position.
27) Move the tool holder arm to the working
position;
28) Move the tool forward until its red reference
dot is aligned with the external edge of the rim,
5 mm away from it.
29) Turn the turntable slightly clockwise until
the bead guide lever (see fig. 33), available
upon request, can be inserted into its seat in
the hook tool.
- E - Operator's manual TBE 155
nglIsh
30) Hold back the lever, which will guide the
bead into the rim well and continue rotation
until the tyre is completely mounted.
31) Remove the rim gripper.
Remove the tool by turning the turntable anti-
clockwise and moving it outward.
32) Tilt the tool holder arm to the non-working
position.
33) Position the platform under the wheel,
lower the turntable until the wheel rests on
the platform.
34) Move the mobile control unit to working
position B.
32
35) With the tyre resting on the platform,
check that the valve is perfectly centred with
its hole.
Otherwise, turn the turntable slightly to adjust
its position.
Fasten the valve with the ring nut and remove
the extension.
36) Completely close the turntable clamps, mak-
ing sure that the wheel is supported to prevent
it from falling.
WARNING
This operation can be extremely dangerous!
Perform it manually if you are absolutely
certain you can maintain the wheel equilib-
rium only.
For heavy, large sized wheels you MUST use a
suitable lifting device.
37) Move the platform in order to free the wheel
from the turntable.
38) Remove the wheel.
33
UK
59