Mondolfo Ferro TBE155 Manuel D'utilisation page 50

CLAMPING ALLOY RIMS
To clamp light alloy wheels, a set of alloy
rim clamps (Fig. 14) designed specifically to
clamp these wheels without damaging them,
is available as an option.
The clamps are to be inserted (bayonet-like
mounting) into the clamp support of the turn-
table as shown in figure 15.
Lock the clamp by tightening the screw B, Fig.
15 by hand.
The clamps are supplied with three different
types of plastic insert (A, Fig. 15) to be used
based on the thickness of the rim flange.
A
Clamp the rim as illustrated in fig. 16.
50
The turntable may "slip" during the vari-
ous operating phases when the rims are
clamped on the central hole (especially with
alloy wheels where the specific clamps are
used).
This problem may be avoided by fitting the
RETAINER PIN accessory (Fig. 17A) into one of
14
the wheel fastener holes (see Fig. 17B).
B
15
As the pin turns it rests against the clamp,
pulling the rim with it and preventing it from
slipping.
A specific gripper for alloy wheels (see Fig.
18) is also available for working with alloy
wheels.
16
Never leave your work station with the
wheel clamped on the turntable and lifted
off the ground.
WARNING:
WARNING
- Operator's manual TBE 155
- E
nglIsh
17A
17B
18