Publicité
Les langues disponibles
Les langues disponibles
5.2.2.12 Dipole vector automatic
•
Push button [7] to select
•
Push button [8], select
•
Selection of automatic dipole vector current:
Select
•
Carrier wave selection:
Push button [9] to select
•
Beat frequency:
Select
•
Modulation frequency (spectrum):
Select
•
Modulation time (spectrum):
Select
•
Treatment time:
Select
•
Rotation speed
Select
•
Select CC or CV with button [13] and the central controller [16];
•
Adjust the current intensity with controller [17].
5.3
Measures with regard to treatments
5.3.1
Electrotherapy
5.3.1.1 Before treatment
•
Check the patient for absolute and relative contraindications.
•
Test the heat sensibility of the treatment area.
•
If the skin is hairy shaving is the best.
5.4
Memory functions
The Endomed 482 is equipped with a memory to store equipment settings and protocols.
5.4.1. Equipment settings
Equipment settings store all parameters of the apparatus, except the current intensity. Contrary to
protocols, equipment settings operate on all channels together, including the ultrasound channel.
Equipment settings are stored at locations 0 - 9. The location number will appear on the display when
button [15] is pushed. Equipment setting 0 is automatically loaded when the apparatus is turned on.
Equipment settings can only be loaded and stored when all channels are inactive.
5.4.1.1. Loading equipment settings
•
Push button [15],
•
Select a memory location in the range of 0 - 9 with the central controller [16]. The display shows the
equipment settings that are stored at the selected location;
•
Push button [14] to load the selected equipment settings;
•
Adjust the current intensity with controller [17];
•
Push button [14] to start the therapy in case a surge program was selected.
Loading the selected equipment settings has to occur within a certain time delay as long as
Waiting too long, or pushing any other button than [14] or [15] will cancel the load operation.
.
5.4.1.2. Storing equipment settings
•
Select a therapy and set all parameters on all desired channels;
•
Push button [15],
•
Select a memory location in the range of 0 - 9 with the central controller [16]. The display shows the
equipment settings that are stored at the selected location, allowing you to check what will be
overwritten;
•
Push button [15] a second time,
that are to be stored at the selected location;
•
Push button [14] to execute the store operation.
Execution of the store operation has to occur within a certain time delay as long as
too long, or pushing any other button than [14] or [15] will cancel the store operation.
GB
12
. Use the central controller [16] to link the channels;
with the central controller [16] and press button [14] to accept;
with the central controller [16] and press button [14] to accept;
(kHz) and adjust its value with the central controller [16];
with button [10] and adjust its value with the central controller [16];
with button [10] and adjust its value with the central controller [16];
with button [11] and adjust its value with the central controller [16];
with button [12] and adjust its value with the central controller [16];
with button [12] and adjust its value with the central controller [16];
is blinking;
is blinking;
is blinking. The display now shows the current equipment settings
is blinking.
is blinking. Waiting
Publicité
