•
Hold time:
Select
with button [12] and adjust its value with the central controller [16];
•
Ramp down time:
Select
with button [12] and adjust its value with the central controller [16];
•
Interval time:
Select
with button [12] and adjust its value with the central controller [16];
•
Delay time (only available with linked channels):
Push button [13] and select channel 2 with the central controller [16].
Select
with button [12] and adjust its value with the central controller [16];
•
Select CC or CV with button [13] and the central controller [16];
•
Polarity:
Select
or
with button [13] and the central controller [16];
•
Select the desired channel with button [13] and the central controller [16]. Adjust the current intensity
with controller [17];
•
Push button [14] to start the therapy in case a surge program was selected.
5.2.2.5 Microcurrent
•
Push button [7] to select
channels;
•
Push button [8], select
•
Frequency:
Select
(Hz or kHz) with button [9] and adjust its value with the central controller [16];
•
Alternating or not alternating:
Select
or
with button [9] and the central controller [16];
•
Treatment time:
Select
with button [12] and adjust its value with the central controller [16];
•
Alternation sequence (only with
•
Ramp up time:
Select
with button [12] and adjust its value with the central controller [16];
•
Hold time:
Select
with button [12] and adjust its value with the central controller [16];
•
Ramp down time:
Select
with button [12] and adjust its value with the central controller [16];
•
Surge program (only with
•
Ramp up time:
Select
with button [12] and adjust its value with the central controller [16];
•
Hold time:
Select
with button [12] and adjust its value with the central controller [16];
•
Ramp down time:
Select
with button [12] and adjust its value with the central controller [16];
•
Interval time:
Select
with button [12] and adjust its value with the central controller [16];
•
Delay time (only available with linked channels):
Push button [13] and select channel 2 with the central controller [16].
Select
with button [12] and adjust its value with the central controller [16];
•
Polarity (only with
Select
or
with button [13] and the central controller [16];
•
Select the desired channel with button [13] and the central controller [16]. Adjust the current intensity
with controller [17];
•
Push button [14] to start the therapy in case a surge program was selected.
5.2.2.6 High voltage
•
Push button [7] to select
channels;
•
Push button [8], select
•
Alternating or not alternating:
Select
or
with button [9] and the central controller [16];
•
Beat frequency:
Select
with button [10] and adjust its value with the central controller [16];
•
Modulation frequency (spectrum):
Select
(%) with button [10] and adjust its value with the central controller [16];
•
Modulation time (spectrum):
Select
with button [11] and adjust its value with the central controller [16];
•
Treatment time:
. Use the central controller [16] to select the desired channel or to link the
with the central controller [16] and press button [14] to accept;
selected):
selected):
selected):
. Use the central controller [16] to select the desired channel or to link the
with the central controller [16] and press button [14] to accept;
GB
9