SilverCrest SMA 500 G1 Mode D'emploi page 45

7.7 Making cold milk froth
•
Insert the whisk (3) up to the stop on the drive shaft inside the canister (5).
•
Take the canister (5) off the base (10) and pour milk up to the MIN marking inside the canister (5). The
volume of the milk increases during the frothing process. Only pour milk up to the lower MAX marking in
order to prevent the milk froth from overflowing.
•
Place the lid (1) onto the canister (5).
•
Place the canister (5) onto the base (10).
•
Use the button (7) to select operating mode 4. The symbol of the operating mode 4 (9) flashes and the whisk
(3) begins to turn after approximately three seconds. The process of creating milk froth begins.
•
As soon as the milk froth is ready, the milk frother automatically switches off and the symbol of the selected
operating mode (9) flashes; it then goes out again after a short time.
You can stop the preparation process at any time by briefly pressing the button (7).
•
Wait around 30 seconds until any remaining liquid milk settles at the bottom of the canister (5).
•
Lift the canister (5) off the base (10), remove the lid (1) and use the milk froth as you wish.
7.8 Heating milk evenly
•
Insert the whisk (3) up to the stop on the drive shaft inside the canister (5).
•
Take the canister (5) off the base (10) and pour milk up to the MIN marking inside the canister (5). Only
pour milk up to the upper MAX marking in order to prevent the hot milk from overflowing.
•
Place the lid (1) onto the canister (5).
•
Place the canister (5) onto the base (10).
•
Use the button (7) to select operating mode 3. The symbol of the operating mode 3 (8) flashes and after
approximately three seconds the whisk (3) begins to turn, thus ensuring even heating.
•
As soon as the milk is hot, the milk frother automatically switches off and the symbol of the selected operating
mode (8) flashes; it then goes out again after a short time.
You can stop the preparation process at any time by briefly pressing the button (7).
•
Lift the canister (5) off the base (10), remove the lid (1) and use the hot milk as you wish.
•
Wait two to three minutes before using the milk frother again.
•
Clean the milk frother with tap water after each use to remove any residues.
•
Be aware that the milk frother may retain a certain level of residual heat after frothing warm milk.
SilverCrest SMA 500 G1
English - 43