SilverCrest SMA 500 G1 Mode D'emploi page 41

6. Before initial use
Remove the SMA 500 G1 milk frother and all accessories from the packaging and check the completeness of the
delivery. Remove any protective films as well as the ILAG sticker, which you can find inside the canister (5).
Keep the packaging material away from children and dispose of it in an environmentally-friendly manner.
7. Initial use
Before you prepare milk for consumption for the first time, you must first clean the milk frother in order to remove
dust and any remnants of the packaging material. Follow the procedure described in the 'Maintenance/cleaning'
section.
DANGER of electric shock
Keep the base (10) away from water. There is danger of electric shock.
WARNING – Risk of burns
Only operate the milk frother with the lid (1) on.
The surface of the heating element will still be hot after use.
WARNING – Risk of injury
Always use fresh milk. Do not consume milk that has been sitting in the canister (5) for a long
period of time.
Please note:
If you lift the canister (5) off the base (10) during operation, the preparation process stops
automatically. Place the canister (5) onto the base (10) again and restart the process using the
button (7).
Cable rewind
A built-in cable rewind is located on the bottom
of the base (10). You can adapt the length of
the power cable (11) to the conditions at your
location.
You can minimise the length of the cable when
you are not using the milk frother.
•
Unwind the power cable (11) on the underside of the base (10) against the direction of the arrow.
SilverCrest SMA 500 G1
English - 39