Zippie VOYAGE Manuel D'utilisation page 19

VIII. SET–UP & USE
Rotating the seat shell direction:
1. Lock the wheels, remove the seat.
2. Be sure the Tilt setting is at the "home" or 0° position. Do this by squeezing the Tilt
Release lever and letting the "Slide-n-Lock" (Receiver) plate spring flat.
3. STEP 1: Press the gold button, Numbered 1 (A) on the Slide-n-Lock plate and rotate
the plate until it stops (Fig 17).
4. STEP 2: Pull the Pin (B) with one hand and rotate the Tilt Limiter Sleeve (C) with your
other hand* (Fig 18 and 19).
5. -NOTE: Only rotate the Tilt Limiter Sleeve in the process of rotating the Plate.
6. *When the seat is forward facing the Tilt Limiter Sleeve should be rotated rearward,
when the seat is rearward facing the Sleeve should be rotated Forward.
7. STEP 3: Finish rotating the Plate 180° until it locks into place. (Fig. 17.1)
NOTE – When fitted with an Advanced Seating system, maximum posterior (forward) tilt
range may be limited.
Insert or remove the Grab Handle:
Always stabilize the mobility device before performing the action.
• Rotate the front casters until they point forward.
• Engage the parking brake.
8. Be careful to avoid pulling or crimping any life support tubing that may be
attached to the child. This adjustment can create a pinch point, so be careful to
remove any obstruction, and/or clothing that could get stuck in this area.
9. The adjustment is made from the front of the device. Depress both detent pins (E)
simultaneously, and either insert or remove the Grab handle (D).
10. If you are inserting the Grab Handle (D) push the handle in far enough so that the
detent pins pop out of the locking hole (E).
11. Pull up on the handle to make sure that it is locked into place.
12. Depending on preference, the grab bar is reversible.
G. TILT IN SPACE ANGLE ADJUSTMENT
WARNING
BEFORE using the tilt adjustment, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. Be careful
to avoid pulling or crimping any life support tubing that may be attached to the child.
Always remember to stabilize the mobility device before performing this action.
• Rotate the front casters until they point forward.
• Engage the parking brake.
17 17.1 18 19
20
19
EN G L I SH
EN G L I SH
A
B
C
B
D
E
MK-100301 Rev.L
17
B
17.1
18
19
20