Télécharger Imprimer la page

Zippie VOYAGE Manuel D'utilisation page 16

Masquer les pouces Voir aussi pour VOYAGE:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

VIII. SET–UP & USE
A. UNFOLDING AND FOLDING BASE FRAME
WARNING
1.
Zippie dependent mobility devices are designed for stability and performance. When
unfolded, the device must be fully open and locked to avoid injury to the dependent
rider.
2.
Follow the instructions for unfolding the device carefully, and double-check that the
device is fully locked before adding the seating shell and rider.
3.
Be careful not to trap or pinch your fingers.
4
5
Unfolding:
1. Unsnap the storage lock (A) from around the folded frame. It should remain attached
to the frame for future use.
2. Pull up on the upper frame (B) until it looks into place. It may be necesaary to put
your foot on the bottom bar while pulling up on the upper frame (Fig. 6).
3. Rear wheels and front casters can now be attached if they are not attached already.
7
6
Folding:
WARNING
The Voyage is not intended to be folded with the seating system installed. ALWAYS
remove the seating system prior to folding the base. Failure to do this may damage the
product.
1.
Remove the child from the seating shell, then remove the seating shell (refer to sub-
section (F)
2.
Unlock the front caster wheels.
3.
Return handle to the straight position as show in Fig. 7.
4.
Set parking brake.
5.
Pull up on both triggers (D) at the same time. This action will release the frame lock.
Continue pulling up on the triggers while pushing down on the upper frame.
6.
Push handle down to begin folding of the base.
7.
Lift on the center tube of the Slide-N-Lock (C). Fig. 6.
8.
Snap the storage lock (A) around the upper frame to prevent the frame from opening
when transporting, or storing the frame.
NOTE: Rear wheels, or front casters do not have to be removed for this procedure, but
may be removed to save space for storage.
If you decide to leave the front casters on the device, it may not lock correctly due to
interference between the caster wheels and the push handle.
In most cases you should fully retract the push handle before folding, then you will be able
to snap the storage lock easily. Do not force the base open or closed if it sticks during
unfolding or folding, damage could occur.
MK-100301 Rev.L
6
4
16
EN G L I SH
4
A
5
B
6
C
7
D

Publicité

loading

Ce manuel est également adapté pour:

Mk-100301