illy FAS 400T Manuel D'utilisation page 70

68
N° ERROR MESSAGE
105 Nozzles movement
error
E
N
G
L
106 Sugar/stirrer
I dispenser
S
H
110 Delivery time-out
(selections with
espresso)
114 Cup dispenser with
photocell error
115 Probe temperature.
116 Communication error
117 Delivery time-out
(selections with hot
instant beverages)
118 Error on air break
micro
119 Cup delivery micro
130 Payment system out
of service.
SUB-
CAUSE OF THE ERROR
CODE
1 The nozzles are unable to
complete the reset cycle
when the machine is
restarted
2 Incorrect microswitch
movement when dispensing
position is reached
3 The nozzles are unable to
reach the dispensing
position
4 The nozzles are unable to
return to the home position
5 Incorrect microswitch
movement when returning
to the home position
1 The device is blocked in
its home position
2 The device is activated but
is unable to return to its
home position
3 Incorrect microswitch
movement
The impulse time counted
by the volumetric meter
exceeds the time-out
Cup not detected
The machine has detected
a boiler temperature fault
39 No communication with the
Snack & Food slave
1 The impulse time counted
by the volumetric meter
2
exceeds the time-out.
3
4
During dispensing, no water
is requested
The cup release motor
hasn't completed the
rotation
illycaffè S.p.A. - Via Flavia 110 - 34147 Trieste - Italy -
FAS 400T MPS.M - ISSUE 01
SOLUTION
Remove any possible obstacles.

 Remove any possible dirt from inside the
assembly.
 Make sure the nozzle microswitch (CDB) is
working properly.
Make sure the nozzle movement gearmotor

(MTBC) is working properly.
 Remove any sugar residue from inside
the sugar dispenser
 Make sure the stirrer dispenser
microswitch (CDZP) is working
properly.
 Make sure the sugar stirrer gearmotor
(MTZP) is working properly.
 Check the fan.
 Clean the coffee unit filters, as they are
clogged.
 Check the water pump is working properly.
 The coffee solenoid valve does not open, or
is clogged.
 Check the photocell and reflector are
correctly assembled.
 Check the cup photocell input switches
correctly.
Check the probe temperature.

Make sure the boiler safety thermostat has

not been triggered
Check the connection cable

Check the master and slave boards are

working properly
Check the fan.

Check the water pump.

The solenoid valve indicated by the sub-

code does not open.
Check the air-break microswitch is working

properly, and that the float is not jammed
 Check the cup delivery microswitch (CMB)
is working properly
 Check the correct operation of the cup
release gear motor (MS)
Payment system disconnected,

powered, or faulty
www.illy.com
not