Horizon Hobby E-FLITE Turbo Timber SWS 2.0m EFL71750 Manuel D'utilisation page 5

Model Assembly ARF/BNF Basic
Removing Wrinkles ARF/BNF Basic
The covering of your model may develop wrinkles during shipping and require the
use of a heat gun and covering glove or covering iron with a sealing iron sock to
remove them. Use caution while working around areas where the colors overlap to
prevent separating the colors. Avoid using too much heat, which could separate the
colors. Placing a cool damp cloth on adjacent colors will also help in preventing the
separation of the colors while removing wrinkles.
Servo Selection and Installation ARF
The recommended servos for this aircraft are the Spektrum A6380 Digital High-
Voltage Servo (SPMSA6380). Six servos are required for this model. If you choose
to install different servos, ensure they have the same or higher specifications for
torque and speed, at a similar weight.
Rudder and Elevator Servo Installation
1. Locate the servo positions and mark the servo mounting holes.
2. Drill a 1/16" (1.5mm) pilot hole for each mounting screw.
3. Thread one of the self-tapping screws included with the servos to cut threads
in all the servo mounting screw holes with a 2mm hex wrench, remove the
screw.
4. Apply one drop of thin CA glue in each screw hole. Allow the CA to cure, do not
use accelerator. Repeat this process for all servo mounting locations.
5. Guide the servo leads through the fuselage.
6. Install the servos as shown, with the output shaft oriented toward the front of
the model in all mounting locations.
7. Secure the servos in place with the included self-tapping screws using a 2mm
hex wrench.
8. Center the servo using the radio system.
9. Place the servo arm on the servo so it is perpendicular to the servo centerline.
Install the servo arm retainer screws included with your servos.
CAUTION: Incorrect installation of the servos could cause a crash. Always
perform a control surface check after making any changes.
EN
Rudder
Elevator
5