Horizon Hobby E-FLITE Turbo Timber SWS 2.0m EFL71750 Manuel D'utilisation page 18

EN
7. Use a drill and 2mm drill bit to drill the remaining holes.
8. Thread one of the M3 x 10mm self-tapping screws into each hole to cut
threads with a Phillips screwdriver (PH#0), remove the screw.
9. Apply one drop of thin CA glue to each screw hole. Allow the CA to cure, do not
use accelerator. Repeat this process for all mounting locations.
10. Secure the straps using M3 x 10 sheet metal screws.
11. Repeat the previous steps to secure the rear strut. Make sure to drill into the
hardwood located in the fuselage near the mounting slot.
12. Use a hobby knife and #11 blade to remove the covering exposing the holes
for the angle support struts. (The holes can be seen easier from inside the
fuselage.)
13. Install the angle support struts, securing them to the fuselage with the two
nylon loop straps and four M3 x 10mm sheet metal screws. The holes for the
screws will need to be drilled in the fuselage.
14. Unplug the rudder servo, and connect the Y-harness included with the float set
to the receiver. Connect the rudder servo to the Y-harness. Cut a small slot in
the fuselage and secure the remaining lead where it can connect to the lead
from the float. Connect the lead from the float and check the operation of the
aircraft rudder and float rudder.
18
Turbo Timber SWS 2.0m