Horizon Hobby E-FLITE Turbo Timber SWS 2.0m EFL71750 Manuel D'utilisation page 25

Dual Rates and Control Throws ARF/BNF Basic
Program your transmitter to set the rates and control throws to the values
given. These values have been tested and are a good starting point to achieve
successful flight.
After flying, you may choose to adjust the values for the desired control response.
Flap to Elevator Mixing ARF/BNF Basic
Program your transmitter to set the Flap System values to those provided here.
These values have been tested and are a good starting point to achieve
successful flight.
After flying, you may choose to adjust the values for the desired control response.
Center of Gravity (CG) ARF/BNF Basic
The CG location is measured from the leading edge of the wing at the root. The
range is 83mm to 107mm back from the leading edge of the wing, we recommend
a starting position of 95mm. Check the CG with the model upright.
NOTICE: Install the battery and hatch but DO NOT connect the battery to the ESC.
Personal injury may result if the battery is connected.
High Rate (100%)
p = 45mm
Aileron
q = 45mm
p = 45mm
Elevator
q = 45mm
 = 50mm
Rudder
 = 50mm
Full
Flaps
q = 45mm
1. Select Flap System
2. Set Pos 0: Flap to 0%, Elevator to 0%
3. Set Pos 1: Flap to 38%, Elevator to 3%
4. Set Pos 2: Flap to 68%, Elevator to 9%
Low Rate (70%)
p = 22mm
q = 22mm
p = 33mm
q = 33mm
 = 30mm
 = 30mm
Partial
q = 22mm
95mm±12mm
EN
25