Horizon Hobby E-FLITE Turbo Timber SWS 2.0m EFL71750 Manuel D'utilisation page 11

Receiver Selection and Installation ARF
The recommended receiver for this aircraft is the Spektrum AR8360T. If you
choose to install a different receiver, ensure that it is at least a 6-channel full range
receiver. Refer to the manual of your chosen receiver for correct installation and
operation instructions.
AR8360T Installation
1. Connect the servos, extensions and ESC to their respective ports on the
receiver using the table at the right.
2. Connect the lighting harness to the unused channel 5 port.
3. Using high quality double-sided servo tape (not included) mount the receiver
to the flat area inside the fuselage as shown. The receiver should be mounted
in the orientation shown, parallel to the length of the fuselage, with the servo
ports facing the front of the aircraft. The orientation of the receiver is critical for
all AS3X and SAFE technology setups.
CAUTION: Incorrect installation of the receiver could cause a crash.
Propeller Adapter Installation ARF/BNF Basic
1. Remove the washer and nut from the prop adapter. Apply a drop of threadlock
on each of the four M3 x 8 socket head cap screws. Mount the prop adapter to
the motor with four M3 x 8mm socket head machine screws using a 2.5mm
hex driver.
Port Assignments
AR8630T
BND/PRG/SRXL2
1 = Throttle 4 = Rudder
2 = Ailerons 5 = Lights
3 = Elevator 6 = Flaps
EN
11