Horizon Hobby E-FLITE Turbo Timber SWS 2.0m EFL71750 Manuel D'utilisation page 13

Connect the Pushrods to the Control Surfaces ARF/BNF Basic
1. Center the servo, so the servo arm is perpendicular to the servo
centerline at neutral.
2. Select the shorter pushrod to connect the servo to the elevator, and the longer
pushrod for the rudder.
3. Insert the bent end of the pushrod into the enlarged hole in the servo arm.
4. Connect the clevis to the control horn. Select a servo arm with output hole
spacing matching the Control Horn and Servo Arm Settings on page13.
5. Verify control surface directions and centering is correct.
CAUTION: Incorrect installation of the servos could cause a crash. Always
perform a control surface check after making any changes.
Control Horn and Servo Arm Settings ARF/BNF Basic
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR8360T
gain values may need to be adjusted. Refer to the Spektrum AR8360T manual
for adjustment of gain values.
After flying, you may choose to adjust the linkage positions for the desired control
response. See the table to the right.
More control throw Less control throw
1.
2.
3.
4.
Control Horns
Elevator
Ailerons
Rudder
Flaps
EN
Servo Arms
19.5mm
25.5mm
15mm
19.5mm
13