Electrical Connection; Installation Of The Control Panel; Fuel Optimisation - Palazzetti IDRO INSERTION Manuel D'installation, D'utilisation Et D'entretien

7.6 Electrical connection

Simply connect the appliance to the electrical
system using the supplied plug (Fig. 27).
The electrical connection (plug) must be easily
accessible after appliance installation as well.
If the power supply cable is damaged
it must be replaced by the technical
assistance service or a qualified techni-
cian in order to prevent any risk.
The system must be equipped with
an earth connection and a differential
switch in compliance with the laws in
force.
The flue gas evacuation duct must
be equipped with its own earth
connection.
5.1.9

Installation of the control panel

The control panel of the stove can be applied to
a plasterboard wall by preparing a hole (see Fig.
24) and applying the fixing bracket supplied with
the two nuts (Fig. 27) on the back.
Do not install the panel in a hot area of
the hood.
Arrange the passage of the cable be-
tween the panel and the stove so that
it is not damaged by the temperature
during normal stove operation.
76
The control panel must be connected, through
its supplied cable, to the stove, on the RJ11 con-
nector (see paragraph "4.1 Description" on page
58).
Fig. 27

7.7 Fuel optimisation

Excellent fuel depends on different factors (type
of installation, operating and maintenance con-
ditions, type of pellets, etc.)
Upon first ignition, the stove can be regulated
for best combustion performance. Generally
speaking, if at the end of combustion, there is a
lot of residue in the burn pot, you should change
the combustion configuration (by increasing the
value) until you find the best solution.
See the function, "Fuel" in the use and operation
manual.
Fig. 28
004778730 - 24/06/2021