Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
INSTALLATION
7.1
General considerations
In the following paragraphs some indications
are provided to be respected in order to obtain
the maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.
7.2 Generator installation on the floor
of a fireplace
In the event of installation in structures with
marble cladding or other materials, the insert
has sliding guides to assist with extracting the
equipment for attaching to the fixing surface
and for carrying out inspections and checks on
the mechanical and electrical components.
5.1.4
Positioning of generator with pedestal
Once the pallet has been removed (refer to the
paragraph "5 HANDLING AND TRANSPORTA-
TION" on page 65) proceed as follows:
• Vary the height of the stove by acting on the
bolts (A - Fig. 17) located on the uprights of the
frame;
• Level the frame by screwing or unscrewing the
gooseneck feet (B - Fig. 17).
• The lower edge of the stove must be at least 10
mm above the marble top of the cladding.
• Drill 4 Ø 8 holes for securing of the frame to the
ground. Use the frame itself as a template.
• Secure the feet (B) of the base with sturdy Ø 8
mm steel expansion plugs (C - Fig. 17);
• Connect the smoke outlet pipe (D - Fig. 17) to
the smoke duct;
• Create the combustion air intake.
004778730 - 24/06/2021
ITALIANO
EXTRACTING THE STOVE
To extract the stove, proceed as follows (Fig. 18):
• Open the door;
• remove the safety bracket by loosening the two
retaining screws (A);
• lift the sliding release lever (B);
• remove the stove, gripping it from inside the
combustion chamber.
This operation acts on a safety micro
switch that turns off the power supply.
ENGLISH
FRANÇAIS
D
B
A
C
Fig. 17
71
Publicité
Chapitres
Table des Matières
