Assembly Diagram - Palazzetti IDRO INSERTION Manuel D'installation, D'utilisation Et D'entretien

• position and fix the base to the fireplace sur-
face with dowels (Fig. 20);
• make all the flue and hydraulic connections;
• reassemble the stove on the telescopic guides
and secure it with the 4 screws (B - Fig. 21)
• reconnect the delivery and return pipes
B
• push the stove into its seat until it is certain that
the automatic locking system is active;
• reposition the safety bracket, securing it with
the two screws (A - Fig. 18)
• close the door again.
The lower part of the supporting base must al-
ways be free to allow for the passage of air to the
stove and cooling air inside the cladding.
004778730 - 24/06/2021
Fig. 20
B
Fig. 21
ITALIANO

7.3 Assembly diagram

A) For correct installation, all the joints of the
smoke ducting between the fireplace and the
flue must be sealed.
B) Rear external air intake, ensure a minimum
distance of 5 cm between cladding and com-
bustion air intake pipe.
C) UNI standards require the installation of a
heat recovery grille as close as possible to the
ceiling.
D) Counter-hood and
structure.
E) Cladding of smoke duct in ecological ceramic
fibre or in rock wool provided with external al-
uminium foil.
F) Protect any wooden parts with fireproof
material.
G) Minimum distance 10 mm between cladding
and insert.
H) The cladding must be made of fireproof
material.
C
D
F
G
H
ENGLISH FRANÇAIS
fireproof load-bearing
A
E
B
Fig. 22
73