Creating Technical Holes On The Cladding - Palazzetti IDRO INSERTION Manuel D'installation, D'utilisation Et D'entretien

5.1.6 Insertion of room sensor
The sensor must be installed near the side or
front suction holes of the cladding base.
Glue the probe wire at the air intakes.
74
7.4 Creating technical holes on the
cladding
The cladding must only be done by qualified
personnel.
Technical holes must be made on the cladding
and on the hood for:
A) the display housing;
B) the heat exhaust ventilation in the hood;
C) the ventilation of the cladding on the base;
D) pellet loading opening
The holes must comply with the measurements
indicated in the figure:
Fig. 23
D
A
2 9
5
5
2 9
1 1
5
C
004778730 - 24/06/2021
B
D
C
Fig. 24