Connection To Flue Pipe; Air Intake Connection - Palazzetti STUFE A LEGNA Mode D'emploi

6.4

CONNECTION TO FLUE PIPE

Dimensioning the flue must be executed in accordance
with EN 13384-1.
• The SMOKE connection between the stove and flue
should have the same cross section as the stove's smoke
outlet. The smoke fitting must be sealed and the use of
flexible metallic pipes is prohibited.
• In order to connect the stove to the chimney you may
perform maximum 3 changes of direction that should not
exceed 90°, the fume duct should not exceed 2 metres
in length and 3 metres in total (- 6.1 -).
• if the outlet is placed on the ceiling, make sure that the
first vertical section has at least 50 cm before changing
the direction.
• Follow the indications in the technical data sheet
regarding the chimney draught value.
6.5

AIR INTAKE CONNECTION

It is necessary to provide an external air intake to
ensure the flow of combustion air to the stove
The dimensions of the hole must comply with the values
set forth in the table of technical data shown in the
"Product booklet".
According to local standards in force, air intake could be
taken directly from the room (- 6.3a -) or connected to
the stove (- 6.3b -).
To get the air directly from the outside, you must install
the connection for the combustion air, on the back of
the stove, after cutting the pretrimmed on the rear of
the stove.
• Is forbidden the intake of air for combustion from
garages, rooms where flammable materials are stored
or where there is danger of fire.
• The combustion air intake should be protected by
an anti-insect grille and placed where it can not be
accidentally obstructed, and made in such a way that the
useful cross-section allows the right amount of oxygen
to reach the stove.
In the room where the stove is located, if there are one
or more extraction fans (exhaust hoods and the like),
there may be problems with combustion due to lack of
combustion air.
22
(-6.2-).
- 6.3a -
004777430 - 18/04/2019 - PALAZZETTI - PN - Italy
x ≤ 2 m
y ≥ 0,5 m
x + y ≤ 3 m
x
y
- 6.1 -
- 6.2 -
- 6.3b -