Ordinary Cleaning; Cleaning The Inside Of The Firebox - Palazzetti IDRO INSERTION Manuel D'installation, D'utilisation Et D'entretien

10.4 Ordinary cleaning

10.5.2 Cleaning the inside of the firebox

Daily or before each ignition, it is necessary to
check that the burn pot is clean to ensure the
free flow of combustion air from the holes of the
burn pot itself.
Vacuum the ash accumulated in the burn pot
(Fig. 36).
ATTENTION: remove the ash from the
combustion chamber because the salts
present cause corrosion of the metal. In
addition, the ash could block the pas-
sage of air, varying the development of
the flame which, if it approaches the
glass, would increase corrosion.
After cleaning the burn pot, remove it from its
seat and clean the compartment that contains it
including the resistor (Fig. 36).
004778730 - 24/06/2021
ITALIANO
Remove the ash drawer and empty it, being sure
to remove any residues in the compartment
where it is contained. Also clean the smoke pas-
sage including the two lower vents (Fig. 37).
Using an ash vacuum can simplify the
cleaning operations
Repeating the previous operations in reverse,
reassemble the drawer and the burn pot.
Fig. 36
ENGLISH FRANÇAIS
Fig. 37
87