Configuration 2 - Room Probe - Palazzetti IDRO INSERTION Manuel D'installation, D'utilisation Et D'entretien

8.2 Configuration 2 - Room probe

8
Componenti compresi nella stufa
Configuration 2 is the default configu-
ration for this appliance. In this case it
is not necessary to make any changes.
Set configuration 2 to switch the appliance
on and off manually or in a programmed way
when the appliance is directly connected to the
radiators.
The appliance modulates the power according to
the room temperature read by the room probe.
The room probe must be positioned
outside the cladding to ensure correct
operation.
You can set the "Eco-mode" function
to have the appliance switch off or on
again according to the room tempera-
ture set.
The antifreeze function can also be set in this
configuration.
80
Sonda temperatura
ambiente
1
8 1
5.1.11 Room probe electrical connection
The appliance leaves the factory with the room
probe already connected to the terminals and
positioned on the rear panel (Fig. 30).
It is possible to place the room probe in another
place to detect the desired room temperature.
8 1
It is important to check that the appli-
ance is set to Configuration 2.
Probe
temperature
room
Fig. 30
004778730 - 24/06/2021