PULOX ABDM50 Manuel D'instruction page 69

EN
Figure 6.4 Set Collection Parameter
As above figure, the doctor could set parameter according to the patient sta-
tus and diagnosis requirement, then the monitor could finish the collection
according to the setting. Parameter explanation is as follows:
Patient Name: the patient's name
Patient ID: the patient's ID number. It is used for marking patient, and it is
exclusive in order to avoid homonymy patient arisen state
Current Time: Current system display time
Time Periods:
Awake Time: the patient is awake state
Asleep Time: the patient is asleep state
Interval: collection Interval.In order to reduce the effect to the patient sleep,
the asleep collection interval should be longer.
For example, as above figure: the awake time area is 7:30-22:30, and the
asleep time area is 22:30-tomorrow7:30. The awake collection interval is 30
minutes, and the asleep collection interval is 60 minutes.
The asleep time area and awake time area will be display at the right side.
When the parameter setting is finished, click " Okay " to upload the project
to the monitor.
6.5 Data Download
Before you download the measurement data from device, please make sure
that:
1. The device is correctly connected to the computer properly.
2. The device is turned on.
3. Disconnect the device from patient before connecting it to the computer.
The downloaded patient data will be saved in case storage path set. If you
want to change the storage path, select "Set file path", the dialogue box (Fig-
ure 6.1.2) will appear, then you can change the path.
Click the shortcut key or "Download" from menu to select the data in
which status is to be obtained, then start to download the data.
6.6 Open Data File
Click "Open Data" to open the case interface shown as below:
69