PULOX ABDM50 Manuel D'instruction page 52

enter into the main interface.
In common user mode, if there is no key-press operation during the time
which system sets, the device will turn off LCD and enter into standby mode,
if there is no any operation in the standby mode, the device will automati-
cally turn off; the "RUN" indicator flashes once every 3 seconds to prompt
the device in working state.
When the power is low, the battery progress bar is empty, at the same time
the prompt sound occurs, and the red indicator flashes in fixed time.
In the Main Interface:
Prompt-switch status is displayed in the left top of the screen;
switch the prompt status shortly.
User bar displays the current patient type (adult, pediatric, neonatal), and
the amount of the common user's data record.
Current date and time are displayed in the middle top of the screen.
Note
◼ All interfaces except the trend retain power icon, prompt switch, as well
as a small font of the current time.
◼ The oldest record will be overwritten after the memory overflows. "Over-
flow" message is shown in the main interface.
3.2 Measuring Interface
Measuring interface displays real-time cuff pressure and the current meas-
urement information. In the meurement process, except the
buttons, other buttons are disabled.
Note
In any interface except the measurement, press
face and back to the boot-strap interface.
3.3 Measure Result Interface
The measure result includes:
SYS: systolic blood pressure (mmHg/kPa)
DIA: diastolic blood pressure (mmHg/kPa)
PR: pulse rate (bpm)
If there is an error during the measurement, an error message text will ap-
pear on the screen. If the PROMPT SOUND is set to be on, the sound would
occur. Press the SILENCE key to stop the sound and press it once more to
continue.
3.4 System Menu
In the main interface, according to the text in the middle bottom of the
screen, press
option operations by using
button, then enter the system menu and execute different
and buttons.
52
button can
and the
key to exit current inter-
EN