PULOX ABDM50 Manuel D'instruction page 51

clean water. Contact a physician immediately. Otherwise, it will cause
blindness or other hazards.
◼ If electrolyte of the batteries immodestly glues on the skin or the clothes,
please immediately flush with plenty of clean water. Otherwise, it may
hurt the skin.
◼ Dispose of the exhausted batteries according to applicable local regula-
tions about environmental. Otherwise, it will cause environmental pollu-
tion.
◼ The monitor is internally powered equipment, can be connected to the
public grid.
2.3 Power on the Instrument
Hold the power button
boot-strap is successful; then release the button, and the system will enter
the main interface.
Hold the power button
shows the shutdown is successful, and the device can be safely terminated.
Warning
If any sign of damage is detected, or the instrument displays some error mes-
sages, do not use it on any patient. Contact biomedical engineer in the hos-
pital or our Customer Service Center immediately.
The device can be used normally after it is turned on, without waiting for the
device to be prepared.
Note
Check all the functions that possibly be used and make sure that the device is in
good status.
2.4 Connect Sensor
Note
For information on correct connection of NIBP cuff, refer to Figure 2.4.1
Connect the sensor between the Monitor and the measure part of the pa-
tient.
Chapter 3 Function Interface
3.1 Main Interface
Press to power on the instrument. The indicator will circularly flash once,
which show the boot-strap is success, then end pressing, the system will
, the indicator will flash once, which shows the
after power on, the indicator will flash once, which
Figure 2.4.1 Connection Method
51
EN