PULOX ABDM50 Manuel D'instruction page 336

●The device should not be used when they are close to or stacked with other
equipment, if necessary, please observe and verify that they can operate nor-
mally in the configurations.
●Devices or systems may still be interfered by other equipment, even if other
equipment meets the requirements of the corresponding national standard.
●The device requires special precautions for electromagnetic compatibility
(EMC) and requires qualified personnel to install and use in accordance with
the EMC information provided below.
●The device should not contact the pins of connectors marked with an ESD
warning symbol, unless electrostatic discharge precautions are used, the de-
vice should not connect to these connectors.
●In order to avoid the accumulation of electrostatic charge, it is recom-
mended to store, maintain and use the equipment at a relative humidity of
30% or more. The floor should be covered with ESD dissipated carpets or
similar materials. In the use of the components, non-synthetic clothing
should be worn.
●In order to prevent electrostatic discharging to the ESD-sensitive parts of
the device, the personnel should contact the metal frame of the components
or the large metal objects near the device. When using the device, especially
when it is possible to contact the ESD-sensitive parts of the device, the oper-
ator should wear a grounded bracelet designed for ESD-sensitive devices. For
more information on proper use, please refer to the instructions provided
with the bracelet.
●All potential users are advised to understand the ESD warning symbols and
receive training on ESD precautions.
●The most basic content of the ESD precautionary procedure training should
include an introduction to electrostatic charge physics, voltage level in the
conventional case, and damage to the electronic components when the op-
erator with electrostatic charge contacts them. In addition, the methods for
preventing electrostatic buildup, and the manner and reasons for the release
of human body static electricity to the ground or equipment frame or the use
of a bracelet to connect the human body to the equipment or the ground
before establishing the connection should be described.
336