Preventive Maintenance Schedule - MCS BV 110E Manuel D'utilisation Et De Maintenance

WARNING: BEFORE PERFORMING ANY MAINTENANCE OR REPAIRS, UNPLUG HEATER FROM
en
THE MAIN POWER SUPPLY AND MAKE SURE THE HEATER IS TOTALLY COOL.
it

11. PREVENTIVE MAINTENANCE SCHEDULE

de
COMPONENT
Fuel tank
es
fr
Filters
nl
Fuel pump filter
pt
Electrodes
da
Fan
fi Combustion chamber
no
12. TROUBLESHOOTING
PROBLEM
sv
The heater does
pl
not start or does
not operate
ru
cs
hu
sl
tr
hr
lt
lv
et
Smoke while
ro operating
sk
The heater does
bg
not turn off
uk
bs
el
zh
MAINTENANCE FREQUENCY
Clean once a year or as required
Clean or replace once a year or as
required (make sure they are intact)
Clean or replace once a year or as
required (make sure they are intact)
Clean as required
Clean as required
Clean as required
POSSIBLE CAUSE
1. Starter switch in "OFF" (0)
position
2. No power supply
3. Power supply cable interrupted
4. Electronic control board
blocked or malfunctioning
5. Incorrect setting of the room
thermostat (if present)
6. No fuel
7. External substances or dirt in
the fuel circuit
1. External substances or dirt in
the fuel circuit
2. Obstructed inlet air vent
1. Faulty electronic system
MAINTENANCE PROCEDURE
Empty and rinse the tank with clean
fuel (SEE PAR. 9.)
Clean the filters (SEE PAR. 8.)
Contact a service centre
Contact a service centre
Contact a service centre
Contact a service centre
POSSIBLE SOLUTION
1. Set starter switch to "ON" (|) position (PIC. 15)
2a. Insert the power plug into the mains socket
correctly (PIC. 14)
2b. Check voltage of your electric supply system
2c. In dual voltage models (...DV) (PIC. 9),
set the switch to the correct voltage position
required
3. Contact a service centre
4a. Reset the heater (SEE PAR. 7.2.)
4b. Contact a service centre
4c. Contact a service centre
5. Set the room thermostat to a temperature
higher than the working environment
temperature (SEE PIC. 16)
6. Top up fuel and reset heater
7a. Empty, rinse and refill the tank
7b. Rinse the filters (SEE PAR. 8.)
7c. Contact a service centre
1a. Empty and refill the tank with clean fuel
1b. Rinse fuel filters
1c. Contact a service centre
2. Remove all air vent obstructions
1. Contact a service centre