Publicité
EC240000
CABLE ROUTING DIAGRAM
1 "ENGINE STOP" button lead
2 Throttle cable
3 Clutch cable
4 Ground lead
5 High tension cord
6 Clamp
7 Air vent hose
8 Radiator breather hose
9 CDI magneto lead
0 YPVS breather hose
q Engine bracket (right)
w Engine bracket (left)
e Crankcase breather hose
r Overflow hose
t Connector cover
CABLE ROUTING DIAGRAM
A Pass the clutch cable on the
outside of the throttle cable and
"ENGINE STOP" button lead.
B Align the throttle cable locating
tape with the cable guide.
C Pass the throttle cable, clutch
cable and "ENGINE STOP"
button lead above the radiator
hose.
D Install the ignition coil, side
core and ground lead together
to the frame. Take care to fas-
ten the ground lead so that its
terminal is within the indicated
range.
E Clamp the throttle cable and
high tension cord to the frame.
2-13
SPEC
F Clamp the clutch cable to the
left engine bracket. Clamp the
clutch cable below the posi-
tioning grommet.
G Pass the air vent hose back of
the throttle cable.
H Pass the air vent hose, over-
flow
hose
and
breather hose between the
frame and connecting rod.
I Pass
the
radiator
hose and YPVS breather hose
outside the engine bracket and
inside the down tube. Then
pass
the
radiator
hose inside the YPVS breather
hose.
crankcase
breather
breather
Publicité
