Connection For Cameras And Led Illuminators Synchronisation; Desiccant Bag; Led Illuminator Activation And Adjustment Instructions; Description Of The Led Illuminator - Videotec ULISSE MAXI Manuel D'instructions

8.10 Connection for cameras and
LED illuminators synchronisation
ZFI cameras fitted with infrared filter: Connect
the camera's Day/Night mode switching input to
the Night Mode connector (dry contact) as shown in
figure.
Fig. 54

8.11 Desiccant bag

Insert the desiccant bags (01) in the position
indicated in the illustration, after having taken them
out from the transparent packaging and folding them
in half. Fasten the sachets by means of the plates (02)
and screws supplied (03).
Fig. 55
30
CN7
Night
Mode
03
02
01
8.12 LED illuminator activation
and adjustment instructions
Once the adjustment is done the illuminator on
the left (MASTER) synchronizes and controls the
illuminator on the right (SLAVE).
The dusk switch detects the room light and controls
the activation and deactivation of the illuminators
when brightness reaches the level set by the user.
A Day/Night switching signal is provided to the
camera upon activation of the LED illuminators (
8.10 Connection for cameras and LED illuminators
synchronisation, page 30).
8.12.1 Description of the LED
illuminator
Do not remove the transparent screw of the
twilight sensor in order not to affect the
security and operation of the illuminator.
• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: The
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: The potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 56
Cable
Infrared power control
MNVCUPTMAXB_1511_EN