Connecting The Direct Control Line Of The Thermal Camera Rs-485-3 (Only For Models With Double Camera); Setting The Ds1 Video Format (Only For Thermal Camera Versions); Termination Of The Rs-485-3 Serial Line (Ds1); Washing System Connection - Videotec Ulisse Compact Manuel D'instructions

6.6 Connecting the direct control
line of the thermal camera RS-
485-3 (only for models with
double camera)
The thermal camera can be externally controlled by
the serial line (CN4, 8.1.16 Thermal Camera Menu,
page 42).
CN4
Fig. 14
6.7 Setting the DS1 video
format (only for thermal camera
versions)
Dip-switch 1 selects the output video format type.
Fig. 15
VIDEO AND TELEMETRY CONFIGURATION (DS1)
Description SW1
Video signal format On
Off
Tab. 5
MNVCUCT_1511_EN
DS1
SW2 Configuration
– PAL video format
– NTSC video format
6.8 Termination of the RS-485-3
serial line (DS1)
Dip-switch 2 enables the termination (120 Ohm) of
the serial line.
Fig. 16
VIDEO AND TELEMETRY CONFIGURATION (DS1)
Description SW1
Serial line termi- –
nation
–
Tab. 6

6.9 Washing system connection

For further details on configuration and
use, refer to the relative manual.
When the washing system is enabled, the
relay 2 is used exclusively for the activation
of the pump (8.1.13 Washer Menu, page 41).
DS1
SW2 Configuration
On RS-485-3 termina-
tion enabled
Off RS-485-3 termina-
tion disabled
17